Command and Processes Table - V

These tables list all commands and processes available in all Datamine Studio products. If your product has access to a command or process, the link on the left of the table displays a help file. If no link appears, the function isn't available in your product.

Symbols used in this table:

A green tick indicates that the module is part of the core system licensing for the specified product - no additional module is required.

X A red cross indicates the module is not part of the listed system and any commands held within it cannot be run (a separate product will be required).

A blue diamond indicates the module is an optional extra for the specified system.

Note: For an explanation of the terms 'command', 'process' and 'macro command', see Command Table Introduction.

For Macro commands, see here.

Commands - V

Command Name

Description

More Help

validate-onthefly-switch

X

X

Use a validation file opened with the open-validation-file command.

vein-from-samples

X

X

X

X

X

X

X

Create vein and vein-like continuous structures from a specified categorical sample attribute.

vertical-length-switch

X

Control whether the HLENGTH field in a blast patterns file is an actual or vertical length.

view-by-one-point

Set the 3D view position and orientation based on a selected point and orientation.

Command Help

view-by-three-points

Set the 3D view position and orientation based on three selected points.

Command Help

view-by-two-points

Set the 3D view position and orientation based on two selected points and orientation.

Command Help

view-to-plot

Change the current Design view to that of a selected plot file (deprecated command).

Command Help

viewset

Opens the View Settings screen to set the section definition and rotate the view interactively.

Command Help

vr-to-plot-create

Create a new plot sheet based on the contents of the active 3D window.

Command Help

vr-to-plot-overlays

Convert existing 3D window overlays to plot sheet overlays.

Command Help

vr-to-plot-section

Convert the current 3D view to a plot section.

Command Help

vr-to-plot-view

Convert the current 3D view to a Plot sheet projection.

Command Help

Processes - V

Process Name

Description

More Help

VALIDA

Validates fields against each other in a Datamine file.

Process Help

VARFIT

X

X

X

The process allows you to display experimental variograms, as produced by the VGRAM process, and fit a model to them using interactive graphics.

VCONTOUR

The VCONTOUR process creates a variogram contour plot.

VER

Displays the current Studio version and build number in the Command control bar, and optionally the version update history.

Process Help

VGM3DMAP

X

X

X

X

X

X

X

Interpolate experimental variogram values into a 3D map (represented by a block model).

VGRAM

X

X

X

X

X

X

X

This process calculates variograms and cross variograms for a range of azimuth and dip directions.